Snow Season Isn’t Over
In the realm of slip and fall prevention, attending to snow and ice control is a given in regions where cold winter temperatures are the norm. At the moment, with spring officially here and warm temperatures in many places, some operators have put snow and ice out of their minds. Yet the season is not fully over; for example, much of the Metro Denver area experienced 3-5 inches of snow this morning and it’s not likely the last snow of the season. I encountered a spot in a parking area this morning that is instructive for those charged with maintaining the safety of parking areas and exterior walkways. Here are two photos of the spot in question. I’ll outline the issues below.
Why Does This Condition Exist?
First, you’ll notice the strip of snow across the walkway, in a localized spot, surrounded by clear sidewalk. The strip of snow if there because the walkway has a drainage channel across that spot, covered by a steel diamond plate cover. Because the steel cover is exposed to air on the bottom, it freezes much sooner than the regular walkway. This phenomenon is the same as what occurs on highway bridges and overpasses. Takeaway: Have you identified spots of special concern in your walking areas and do you know the factors in play?
What About the Cone?
Next, notice that there is a cone in place. It turns out this was placed there a few hours before the photos above were taken. The maintenance person who placed it there put it in place because the steel cover underneath was slippery due a layer of ice on its surface, under the snow. When the cone was placed, the whole walkway was covered with snow. This cone is beneficial because it helps alert pedestrians to the hazard. It is also not ideal because there are several preventative measures that could have been put in place, perhaps removing the need for a cone. Takeaway: Eliminate or reduce hazards first, then deploy warnings.
Possible Corrective Actions
Here is a round-up of possible preventative measures that could have been employed here:
- Use a different material for the cover that would not function as a heat sink and be as prone to freezing.
- Put a textured coating or finish on the cover so it would have better traction when wet or covered in snow.
- Remove the snow from this cover after any snow accumulation, not just after the trigger level of 2-3 inches that prompts full-scale parking lot snow removal.
There may be other solutions as well, but this should give you a good glimpse of how effective risk control requires specific attention to the real-world details of your situation. The sidewalk and cover in question met building code requirements, which is a good start, but in this case prudent risk control takes more than that.